Inspect and document
A licensed roofer checks every panel run, fastener line, and flashing point, photographs the corrosion or seam separation, and finds where water is actually getting under the metal.
We re-torque backed-out fasteners, swap corroded panels, and reseal seams and ridge flashing on standing-seam and exposed-fastener metal roofs across Ensley.
Ferry Pass Roofer services the standing-seam and exposed-fastener metal roofs going up on Ensley's infill bungalows and shops along the Olive Road corridor, where salt-laden Gulf humidity and 68 inches of rain a year back out screws and open seams.
We re-torque or replace EPDM-washer fasteners, swap corroded Galvalume panels, and reseal ridge and headwall flashing so the panels you have keep their remaining service life rather than facing a tear-off.
Four reasons Ensley metal-roof owners call us before a corner becomes a tear-off.
We back out stripped screws, fit oversized EPDM-washer fasteners, and reseal lap seams so an Ensley metal roof stops weeping at the panel joints.
Salt air and 68 inches of yearly rain rust exposed cut edges and fastener holes. We cut out failed Galvalume sections and splice in matched panels.
Ridge caps, headwall flashing, pipe boots, and skylight curbs are the usual leak points. We rebuild them with new metal and compatible sealant.
After a named storm we refasten lifted panels, replace any that creased, and check the underlayment before water tracks under the metal.
Learn more about our metal roof repair services.
Four steps from inspection to a hose-tested, watertight metal roof.
A licensed roofer checks every panel run, fastener line, and flashing point, photographs the corrosion or seam separation, and finds where water is actually getting under the metal.
You get a written estimate broken out by fasteners, panels, and flashing, with a clear note on whether a repair makes sense or the panel system is near the end of its life.
Minor resealing is exempt, while larger panel replacement is permitted through Escambia County Building Services for Ensley's unincorporated blocks.
We complete the fastener, panel, and flashing work, then hose-test the repaired runs and re-check the seams so the metal roof is proven watertight before we pack up.
Feedback from Olive Road, Magnolia Place, and East Ensley metal-roof owners.
Screws were backing out all over our metal roof and it leaked at two seams. They re-fastened the whole field and resealed the seams, and it has been dry since.
One panel had rusted through near the ridge. Ferry Pass Roofer cut it out and matched a new one so well you can't tell where the repair is.
Honest crew. They told me the roof had plenty of life left and just needed the flashing redone instead of selling me a replacement.
We cover the 32514 wedge of Ensley along the Olive Road corridor and east toward Ferry Pass.
Whether metal roofs are repairable, their weak points, and Florida's roof rules.
Areas We Serve in Ensley